5 Pressthe
+or–buttonto
Introduction
The contents of this document may be changed in the future without advanced
notice. Contact our Customer Support Center for the latest information relating to
product names and model numbers.
The utmost care has been taken to ensure the integrity of the contents of this
document. In the unlikely event that a questionable item, error, or omission is
found, please contact our Customer Support Center.
Any liability for passive damages or damage of any kind occurred due to data loss
incurred by a defect of the product, repair performed by the third party other
than Olympus or an Olympus authorized service station, or any other reason is
excluded.
hInserting Batteries
hLCD Display Information
hLocating the Beginning of the File
set.
•
Follow the same steps by press-
ing the 9 or 0 button to
elect the next item, and press
the + or – button to set.
You can select an option for the display of the recorder. This will help review and confirm different
recorder settings and file information.
1 Lightly press down on the arrow and
Whiletherecorderisduringplaybackmode(playback
•
•
•
or playback in slow/fast mode), press the 9 or 0
slide the battery cover open.
1. 1‘08 12:00AM
7.25‘08 3:00PM
button.
DIGITAL VOICE RECORDER
State of the
recorder
Operation
Display
•
Jumps to the beginning of the next file or the file being
played back.
6 Press the PLAY/OK (`)
VN-6200PC
VN-5200PC
VN-3200PC
While in stop
mode
Press and hold the
STOP (4) button
Whileholdingthebuttondown,“Remainingrecording
time” and “Remaining memory” are displayed.
button to complete the
setup screen.
•
The clock will start from the set
date and time.
While in record
mode
Press the DISP/
MENU button
Each press switches the display in the order
of “Recording elapsed time”, “Remaining
recording time” and “Recording level meter”.
2 Inserttwosize-AAAalkalinebatteries,
Note:
•
Press the PLAY/OK (`) button
according to the time signal.
•
If there is an index mark or temp mark in the middle of the file, the recorder will stop at that
location.
observing the correct polarity.
While in stop
mode or
playback mode
Press the DISP/
MENU button
Each press switches the display in the order of
“Playback elapsed time”, “Remaining playback
time”, “Date of recording” and “Time at
recording”.
Trademarks and registered trademarks:
7 Press the STOP (4) button to close the menu
EN
INSTRUCTIONS
•
Microsoft, Windows and Windows Media are registered
trademarks of Microsoft Corporation.
Macintosh is the trademark of Apple Inc.
mode.
Thank you for purchasing an Olympus Digital Voice Recorder.
Please read these instructions for information
about using the product correctly and safely.
•
This completes the time and date setup procedure.
hChanging the Playback Speed
•
Notes:
Other product and brand names mentioned herein may be
thetrademarksorregisteredtrademarksoftheirrespective
owners.
•
You can choose between 12 and 24 hour display by pressing the DISP/MENU button while setting
the hour and minute.
You can change the order of the date indication by pressing the DISP/MENU button while you
are setting the year, month, or day.
Whiletherecorderisduringplaybackmode, pressthe
PLAY OK (`) button to change the playback speed.
Keep the instructions handy for future reference.
3 Close the battery cover completely.
Playback
/
•
When the HOLD switch is set to the direction
of the arrow, the display is turned off after
[HOLD] is displayed. Follow the next step
without regard to it.
•
To ensure successful recordings, we recommend that
you test the record function and volume before use.
hSafe and Proper Usage
Slow Playback
(-25%)
Fast Playback
(+50%)
Normal speed
hPlayback
Before using your new recorder, read this manual carefully to ensure that you know how to operate
it safely and correctly. Keep this manual in an easily accessible location for future reference.
An optional Ni-MH Rechargeable Battery (BR401)
from Olympus can be used for the recorder.
1 Press the FOLDER
the desired folder.
/INDEX button to select
•
The warning symbols indicate important safety related information. To protect yourself and others from
personal injury or damage to property, it is essential that you always read the warnings and information
provided.
Recording
Shinjuku Monolith, 3-1 Nishi-Shinjuku 2-chome, Shinjyuku-ku, Tokyo 163-0914, Japan. Tel. +81 (0)3-3340-2111
Notes:
Replacing the Batteries:
•
When the slow playback mode is selected, the [J] appears and, for the fast playback mode, [K]
Current folder
appears on the display.
hNotes on the Folders
When [N] appears on the display, replace the batteries as soon as possible. Size-AAA alkaline
batteries are recommended. When the batteries are depleted, [O] appears on the display, and
the recor-der shuts off.
•
•
Even if playback is stopped, the changed playback speed will be retained.
The next playback will be at that speed.
Getting Started
The recorder provides five folders, [F], [G], [H], [I] and [ ]. To
3500 Corporate Parkway, P.O. Box 610, Center Valley, PA 18034-0610, U.S.A. Tel. 1-888-553-4448
change the folder selection, press the FOLDER/INDEX button while
2 Pressthe9or0buttontoselectthefile
the recorder is stopped.
Note:
•
•
To replace the battery, make sure that you set the HOLD switch to the opposite direction of the
arrow before replacing.
to playback.
Up to a total of 200 files can be recorded in each folder.
hIdentification of Parts
Erase
1 Built-in Microphone
0
EAR (Earphone)
0
!
hPower Supply
1
2
jack
2
MIC(Microphone)
Poweron:SlidetheHOLDswitchinthedirection
opposite that indicated by the arrow.
Power off: Slide the HOLD switch in the
direction indicated by the arrow while the
recorder is not in operation.
You can easily erase unnecessary files. Sequential file numbers are reassigned automatically.
jack
! Display (LCD panel)
@ Record/play
3 Press the PLAY/OK (`)
hRecording
a
3
HOLD switch
button to start playback.
hErasing One File at a Time
indicator light
4 USB terminal
•
The record/play indicator light
turns green, and the elapsed
playing time is indicated on
the display.
1 Press the FOLDER
/
#
$
REC (s) button
5
6
STOP (4) button
PLAY OK (`)
button
INDEX button to select
+
button
/
1 Press the FOLDER
/
INDEX button to select
the desired folder.
15m15s
14m25s
Standby Mode and Display Shut Off:
% 9 (Fast Forward)
a Current folder
folder.
a Current file number
b Playing time
3
button
a
b
7 0 (Rewind)
15m15s
14m15s
If the recorder is stopped for 5 minutes or longer during
recording or playing, it goes into Standby (power-save)
mode, and the display shuts off. To exit Standby mode
and turn on the display, press any button.
For customers in North and South America:
button
^
&
*
–
button
8 Battery cover
9
DISP
/MENU button
4 Press the + or – button to select the proper
2 Press the REC (s) but-
FOLDER/INDEX
ERASE (s) button
@
#
sound volume.
4
5
ton to start recording.
Declaration of Conformity
button
( Strap hole
•
Thedisplayshowsthevolumelevel. Youcanchoosebetween
[00] to [30].
a
•
•
The record/play indicator light
turns red, and recording starts.
If you start recording after in-
serting the earphone into the
earphone jack on the recorder,
you can hear the sound being
recorded. The sound volume
on the recording monitor can
be adjusted by pressing the +
or – button.
Model Number:
Trade Name:
VN-6200PC/VN-5200PC/VN-3200PC
DIGITAL VOICE RECORDER
2 Press the 9 or 0
$
button to select the file
hHold
6
7
Responsible Party: OLYMPUS IMAGING AMERICA INC.
Address: 3500 Corporate Parkway, P.O. Box 610, Center Valley,
PA 18034-0610,U.S.A.
15m15s
14m15s
to be erased.
%
^
&
Setting the HOLD switch to the direction of the arrow holds the current status, and all button
aFile to be erased
b c
d
operations are disabled. Remember to release the HOLD switch to use the recorder.
hCanceling Playback
3 Press the ERASE (s )
Telephone Number: 1-888-553-4448
To Stop:
button.
8
9
This device Complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Remain 22h52m46s
(
Press the STOP (4) button.
The recorder stops in the middle of the file being played.
hSetting Time and Date [Time & Date
]
*
b Current recording mode
c Current file number
d Recording time
e Remaining recording time
f Recording level meter
•
e
If you have set the time and date, information as to when a sound file was recorded is stored
automatically with that file.
•
Strap is not supplied. Use
the optional accessory.
4 Press the 9 button to select [Start].
5 Press the PLAY/OK(`) button.
When you install batteries for the first time or each time you replace the batteries, the
“Month” indication will flash. In such a case, be sure to set the time and date by following
steps 4 through 6 described below.
To Resume Playback:
Tested To Comply
With FCC Standards
f
Press the PLAY
/OK (`) button again.
3 Press the STOP (4) button to stop record-
•
Playback will resume at the point of interruption.
Display (LCD panel):
1 Press and hold the DISP/MENU button for 1
FOR HOME OR OFFICE USE
ing.
second or longer to go to the main menu.
•
New recordings are saved as the last file in the folder.
Canadian RFI:
Erase:
Start
File Erase!
5
1
2
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Cet appareil numérique ne dépasse pas les limites de la Catégorie B pour les émissions de bruit
radio émanant d’appareils numériques, tel que prévu dans les Règlements sur l’Interférence
Radio du Département Canadien des Communications.
hForwarding and Rewinding
hErase All Files from a Folder
Fast Forward:
6
7
a
2 Press the 9 or 0
3
4
hTo Pause Recording
button to select
Whiletherecorderisduringplaybackmode,pressand
1 Press the FOLDER
/
[
Sub Menu].
hold the 9 button.
INDEX button to select
To Pause:
•
When you release the 9 button, the recorder will resume
normal playback.
3 Press the PLAY
/OK (`)
the folder to be erased.
aFolder to be erased
Time & Date
button.
While the recorder is during
recordingmode, presstheREC
(s) button.
•
[Time & Date] appears on the
display, and [ ] flashes.
1 Folder indicator
2 [ ] Microphone sensitivity
3 Guide indicator
Rewind:
4 Character information display
Recording level meter
5 Battery indicator
•
[Rec Pause] appears on the display.
Rec Pause
indicator
While the recorder is during playback mode, press and hold the 0 button.
4 Press the 9 or 0
buttontoselecttheitem
to set.
[
] Variable Control Voice
•
When you release the 0 button, the recorder will resume normal playback.
2 Press the ERASE (s )
Actuator indicator
6 Erase lock indicator
7 Current file number
Notes:
button twice.
To Resume Recording:
[
] Record mode indicator
•
The recorder pauses when it reaches to the end of the file during fast forwarding or fast rewinding.
Pressing and holding it continues fast-forwarding or fast-rewinding.
If there is an index mark or temp mark in the middle of the file, the recorder will stop at that
location.
•
Select the item from “Month”,
“Day”, “Year”, “Hour” and
“Minute” with a flashing
point.
[K] Fast playback indicator
Press the REC (s) button again.
•
[J] Slow playback indicator
•
Recording will resume at the point of interruption.
1. 1‘08 12:00AM
Erase:
Cancel
U1-BS0175-03
AP0904
1
- -
2
- -
3
- -
4
- -
5
- -
6
- -
|